60 Litre Calorifier - Standard : Penguin Engineering Ltd

Products

Accumulators
Bilge Controls
Bio-Sok
Calorifiers
Connections
Electric Struts
Seat Pedestals
Table Pedestals
Sinks & Basins
S-200 Oil Gone
Taps & Showers
Teak Wonder
Drains & Wastes
Water Filters


				60 Litre Calorifier - Standard

				The latest range of marine water heaters are of excellent quality and have a very attractive price, particularly when one realises that the standard unit incorporates an electrical heater element, an adjustable thermostat, stainless steel mounting brackets, safety valve & drain valve. Thanks to the large surface area of the copper heat exchanger/coil A.T.I water heaters have the ability to produce a large output of hot water. Heat exchanger surface area: 2.100cm2 Measurements: Height with Brackets (D): 334mm Diameter (A): 322mm Width Between Brackets (B): 267mm Length of Body (E): 990mm


	These rugged water heaters have the ability to operate at pressures up to four times atmosphere, which makes them much more suitable for marine applications than units made of copper at comparable cost. The calorifiers are coated with vitreous enamel at high temperature giving a bonded, glass-like protective finish to the inside. There is an anodised aluminium outer casing to protect the polyurethane insulation. All Models give very high performances and efficiency and they are equipped with the following standard components; Copper Heat Exchanger: a wide exchanging-surface allows a large production of sanity hot (even with very small temperature differences), exploiting the heat of the motor cooling water. Heat exchanger surface area: 2.100cm2 Electrical Heater Element: (220 Volt 50 Hz). It is available in three different outputs (500/800/1200W) and is provided with an adjustable thermostat. It allows hot water production even when the engine is off. External Cast: made of anodised aluminium: it is suitable for nautical usage; Thick Heating Insulation: made of expanded polyurethane with closed cells; it reduces the heat loss to 1'C per hour in 24 hours; Magnesium Anode: it protects the tank against galvanic corrosion. Strong Stainless Steel Brackets: they allow a solid, safe and very easy installation; Brass Flange: it permits inspections of the interior of tanks; Safety valve: it protects the tank from possible excessive pressure. Weight: 23Kg Voltage: 220V - 50Hz Electrical Heating Element: 1200 Safety Valve Setting (bar): 4+_1 Testing Pressure: 8 Water Connections: 1/2" Domestic Water Inlet 1/2" Hot Water Outlet 1/2" Motor Cooling Inlet 1/2" Motor Cooling Water Outlet Thermostatic Mixing Valve Kit's are NOT included and are an optional extra as not all customers require these.

	back

Terms & Conditions